Cisco Catalyst 9300/9300L/9400/9500/9600 Series Switches CC Configuration Guide

1. The administrator will be prompted to enter the initial configuration dialog. Enter no and confirm you would like to terminateautoinstall. The CC Configuration will use manual steps to provide the initial configuration.

Would you like to enter the initial configuration dialog? [yes/no]: no

Would you like to terminate autoinstall? [yes]:yes

Press RETURN to get started!

2. Enter privilege EXEC mode

SWITCH> enable

3. EnterConfigurar el terminal

SWITCH# configure terminal

4. Configure a hostname

SWITCH(config)#hostname mySWITCH

5. Configure the Enable Secret Password using Type 9

SWITCH(config)#enable algorithm-type scrypt secret <the unencrypted (cleartext)'enable' secret>

Nota:Compose a password with a length between 8 and 16 using any combination of upper and lower case letters,numbers, and the following special characters: “!”, “@”, “#”, “$”, “%”, “^”, “&”, “*”, “(“, “)

6. Provide an initial configuration for an Out-of-Band Management Interface. For example:

SWITCH(config)#interface GigabitEthernet0/0

SWITCH(config-if)#vrf forwarding Mgmt-vrf

SWITCH(config-if)#ip address <IP address> <mask>

SWITCH(config-if)#no shutdown

SWITCH(config-if)#salida

7. Configure a default route to reach the Switch.

SWITCH(config)#ip route <prefix> <mask> <ip-address>

8. Configure the console to require username and password authentication

SWITCH(config)#Consola de la línea 0

SWITCH(config-line)#login authentication default

9. Save the initial configuration to nvram by executing “wr mem” or “copy system:running-config nvram:startup-config”command.

Note: Instructions for adding additional administrative users are specified in 4.2.14 below.

Cisco Catalyst 9300 Series Switches

Cisco All Series Switches New and Refurbished

For Cisco product list and quote, please visit: https://www.hi-network.com/categories/cisco or contact us at www.hi-network.com  (Email: [email protected] (en inglés))